(SEE PARA. V)
g. Install the Upper Brush Guard Shim (P/N 106759-1) over the Installation Guides.
h. Feed the LH and RH Wiring Extension Harness through the hole in the Lower Brush
k. Using a lift sling and material handling equipment (hoist, forklift, etc.), position the
Upper Brush Guard (P/N 111407-1) onto the Installation Guides, over the installed
Shim, and over the Lower Brush Guard with the "up" arrow (↑) facing the installer.
The first and second bolt holes and the sixth and seventh bolt holes from the
passenger-side end of the Upper Brush Guard use two bolts (3/8 - 16 x 4.500
LG), four washers (3/8 ID), and two nuts (3/8 - 16) for proper installation. Hand-
tighten the bolts. (See Paragraph 5.1.6 if the vehicle is equipped with a gun ring
At this time, do not install bolts into the bolt holes over the headlight cutouts on
the Upper Brush Guard.