PARKING BRAKE PAWL ADJUSTMENT- Continued
Do not allow shaft (K) to turn or damage to control (L) will result.
11. Using two 9/16 inch wrenches, loosen two nuts (U) and (V) on end of shaft (K).
12. Push or pull shaft (K) until a 15/16 inch gage block fits between cotter pin (Q) and bottom face of nut (J).
13. Adjust upper nut (U) to allow a 3/16 inch gage block to be placed between the lower face of lever (W), and upper
14. Using two 9/16 inch wrenches hold nut (U) and lock lower nut (V) securely against upper nut (U).
Proceed to step 25.
RIGHT SIDE SHOWN,
LEFT SIDE SAME
ONE-PIECE LEVER AND
PAWL WITH TWO JAMNUTS